Our adjustable trackbar and drop bracket give you the strength and adjustability your lifted XJ/ZJ needs. When you lift your vehicle over 6 inches your stock trackbar angles become fairly steep. It is very important to keep your trackbar and drag link in parallel and as flat as possible to minimize bump steer and gain steering response.
This heavy duty 1/4 inch laser cut trackbar drop bracket lowers the trackbar angles. The bracket bolts into the OEM location, however we do recommend adding a few stich welds for superior strength. This bracket not only minimizes trackbar angles, but puts the trackbar bolt in double sheer adding strength. By using the trackbar in double sheer you eliminate any chance of over flexing the joint.
What is different about this trackbar is the lower bushing. Many customers have complained that their stock, or previous trackbar has loosened up and damaged and/or egged out the factory hole.
This trackbar uses a much larger 9/16s Grade 8 bolt to allow you to drill out your factory location and easily upgrade to this HD bushing. Put it simply, this is the strongest, most adjustable trackbar on the market. Trackbar comes powdercoated while the bracket is bare metal because we recommend welding. Two 9/16s grade 8 bolts are included with this kit.
Bracket is designed to use a 2.5 inch Currie forged johnny joint. Inside diameter of this bracket is 2 5/8s, and it uses a 9/16 bolt. We recommend using this adjustable trackbar and drop bracket with our drop pitman arm with 6-8" of lift.
Trackbar - Center to Center Min = 31-1/8", Max = 32-3/16"
- NOTE: Drilling is required to install this trackbar, This kit requires welding.
- 2.5" forged Johhny Joint adjuster
- 1.5" DOM tubing
- HD mechanically bonded
- Bushing 9/16" grade 8 hardware w/ flanged tab
- 1/4" lowered height
- Double sheer trackbar bracket
- LIfetime Warranty*
- MADE IN THE USA!