This is what you have been waiting for in a DIY bushing kit - it comes with everything you need and is made of 2.0" DOM with a .25" wall for ultimate strength. You get the heavy wall DOM outer sleeve, two high quality Polyurethane bushings, an inner sleeve with a 9/16" ID, and include the optional 1/4" thick mounting tabs and a grade 8 9/16" bolt with washers and a locking nut for ready-to-weld installation.
These are designed to be used in many ways: Motor Mounts, Crossmember mounts, Traction Bar ends, etc. They work great as the bushed end of 3 and 4 link arms too. We made the grease zerk fitting optional so that you can decide if you need that or not. We do not typically use the zerk fitting and have found that anti-sieze during final installation usually works great for a long time. These are available to fit standard 2 5/8" link width. If you would like another width give us a call and we can adjust to the width you would like. Sold individually so order as many as you need for your project by choosing the correct quanity.
- 1x: 2"x.25" wall DOM outer sleeve
- 1x Inner sleeve for a 9/16" bolt
- 2x High quality polyurethane bushings
- 1x 9/16" grade 8 bolt with washers and locking nut
- 2x 1/4" thick mounting tabs with flat bottom
- Sold individually